MAIN FEATURES
* Built-in motion sensor for swift turning on/off
* Water resistance IP67 (protected from all precipitation)
* Type-C charging port
* Red light preserve night vision
* Lightweight body for maximum comfort
INCLUDED
• Headlamp VLF- H015;
• Charging cable;
• Nylon headband;
• User’s manual.
LIGHTING MODES
High – maximum brightness
Low – minimum brightness
Strobe – flashing light
Red on – constant red light
Red flash – flashing red light
OPERATING INSTRUCTION
ON/OFF and selection of modes:
Press the ON button to turn the light on, cycle through
the modes, and turn the light off .
Press and hold the ON button for 0.5 seconds with the
light on to memorize the current lighting mode and turn
off the light. The saved mode will be applied next time.
If more than 5 seconds have passed since the last press
of the ON button, the next press of the button will also
turn off the light and remember the current mode.
SENSOR:
Press the SENSOR button when the light is off to activate the sensor. With the sensor enabled, you can turn the light on and off by waving your hand near the flashlight. Press any button to deactivate the sensor.
To program any lighting mode to turn on with the sensor,
select the desired mode, then press the SENSOR button. Saved mode will be applied until it is changed to another one.
LOCK/UNLOCK:
When the light is off, press and hold the ON/OFF and SENSOR buttons for 3 seconds to lock/unlock the headlamp.
BATTERY STATUS INDICATION
With the light switched off, press and hold the SENSOR button for 0.5 seconds to see the battery status. The indication will last for 2 seconds. The battery status is also continuously displayed when the light is turned on.
4 divisions - 100-80% charge;
3 divisions - 79-50% charge;
2 divisions - 49-25% charge;
1 division - 24-1% charge.
1 division flashes – battery discharged.
CHARGING
Plug the USB-A socket of the charging cable into electrical outlet. Switch off the light, open the protective cover and connect the charging cable to the flashlight port. When charging, the divisions flash indicating the current battery level. When fully charged, all 4 indicator bars are constantly on. After a full charge, unplug the charging cable and close the protective cover to prevent water and dust from entering the headlamp body.
© The original rechargeable batteries are supplied charged and can be used immediately after purchase, however it is recommended that the battery be fully charged before first use. The battery needs to be charged in time before it is completely discharged. During long periods of storage, it is recommended to keep the battery charging level at about half capacity to extend its service life.