MAIN FEATURES
* Built-in motion sensor for swift turning on/off
* Water resistance IP65 (protected from all precipitation)
* Micro USB charging port
* Red light preserves night vision
* Additional low beam COB LED
INCLUDED
• Headlamp VLF-H035C;
• Charging cable;
• Nylon headband;
• User’s manual
LIGHTING MODES
High – main light maximum brightness
Low – main light minimum brightness
COB – low beam light maximum brightness
COB+HIGH – total maximum brightness
Strobe – main light flashing light
Red on – constant red light
Red flash – flashing red light
OPERATING INSTRUCTION
Short press ON button – turn on the light, switch between modes and turn off the light cyclically.
Note. The mode selection performs within 5 seconds. After this time, the next short press will turn the light off . The headlamp automatically memorizes the last selected lighting mode and applies it next time when turned on.
Long press (0.5 seconds) ON button – turn on/off the secondary COB light.
Short press SENSOR button with the light switched off - activate the sensor HIGH mode or the sensor COB mode. After that, you can turn on/off the light by hand waves closely to the device.
Short press SENSOR button with the light switched on - remember current lighting mode and later switch it on/off by the sensor.
BATTERY STATUS INDICATION
Press and hold the SENSOR button for 0.5 seconds to see the battery status. The indication will last for 2 seconds. The battery status is also continuously displayed when the light is turned on.
5 divisions - ≤100% charge;
4 divisions - ≤80% charge;
3 divisions - ≤60% charge;
2 divisions - ≤40% charge;
1 division - ≤20% charge;
1 division flashes – battery discharged
CHARGING
Plug the USB-A socket of the charging cable into the electrical outlet. Switch off the light, open the protective cover and connect the charging cable to the flashlight port.
When charging, the divisions flash indicating the current battery level.
When fully charged, all 5 indicator bars are constantly on.
After a full charge, unplug the charging cable and close the protective cover to prevent water and dust from entering the headlamp body.
© The original rechargeable batteries are supplied charged and can be used immediately after purchase, however it is recommended that the battery be fully charged before first use. The battery needs to be charged in time before it is completely discharged. During long periods of storage, it is recommended to keep the battery charging level at about half capacity to extend its service life.