MAIN FEATURES
*Maximum brightness 500 lumens with two LEDs
*Compatible with Li-ion battery pack or with 3x AAA batteries
*Built-in motion sensor for swift turning on/off
*Water resistance IP65 (protected from all precipitation)
*Type-C charging port
*Red light preserves night vision
INCLUDED
• Headlamp VLF-H055D;
• Charging cable;
• Nylon headband;
• Li-ion rechargeable battery VLF-B12
• Videx alkaline battery AAA 3pcs
• User’s manual.
LIGHTING MODES
High – maximum brightness
Low – low brightness
Moon – minimum brightness
Strobe – flashing light
Red on – constant red light
Red flash – flashing red light
OPERATING INSTRUCTION
Short press ON button – turn on the light, switch between modes and turn off the light cyclically.
Long press (0.5 seconds) ON button with the light switched on - remember current mode and switch the light off . Short press again – turn on the last remembered mode.
Short press SENSOR button with the light switched off - activate the sensor HIGH mode. A blue indicator informs that the sensor is activated. After that, you can turn on/off the light by a hand waves closely to the device
Short press SENSOR button with the light switched on - remember current lighting mode and later switch it on/off by the sensor.
BATTERY STATUS INDICATION
Press and hold the SENSOR button for 0.5 seconds to see the battery status. The indication will last for 3 seconds.
4 divisions - 100-80% charge;
3 divisions - 79-50% charge;
2 divisions - 49-25% charge;
1 division - 24-1% charge.
1 division flashes – battery discharged.
CHARGING
ATTENTION! AAA batteries cannot be charged.
Plug the USB-A socket of the charging cable into the electrical outlet. Switch off the light, open the protective cover and connect the charging cable to the flashlight port.
When charging, the divisions flash indicating the current battery level. When fully charged, all 4 indicator bars are constantly on.
After a full charge, unplug the charging cable and close the protective cover to prevent water and dust from entering the headlamp body.
© The original rechargeable batteries are supplied charged and can be used immediately after purchase, however it is recommended that the battery be fully charged before first use. The battery needs to be charged in time before it is completely discharged. During long periods of storage, it is recommended to keep the battery charging level at about half capacity to extend its service life.
BATTERY REPLACEMENT
a) Fully open the tilt angle adjusting mechanism;
b) Pull up the lock located behind the control buttons and open the back cover;
c) Insert the battery/s according to the diagram shown on the inside of the battery compartment;
d) Close the cover until it snaps and test the headlamp.