The emergency backup light will turn on automatically when the power goes out and the light switch remains on. When the power returns, the lamp will automatically switch from the emergency light state to regular power lighting.
Note! In emergency situations, when the emergency backup indicator turns on, the motion sensor is disabled.
BATTERY CHARGING
When the lamp is used daily, the batteries will be charged automatically, in situation when lamp is used irregular, the batteries are charged every time the light switch is turned on. When the light switch is off, the batteries are not charged. The lamp has a built-in intelligent internal circuit with overcharge, overload and overvoltage protection.
KIT CONTENTS
Lamp with two rechargeable batteries VIDEX Li-ION 18650 2200 mAh
Surface mount kit
User manual
Individual packaging
ASSEMBLY RECOMMENDATIONS
The minimum distance between two ceiling lamps must be at least 3 meters to avoid mutual interference of the sensor.
INSTRUCTIONS FOR USER
Switch #1. Modes setting:
Position 1 - normal mode. The lamp operates in on/off mode;
Position 2 - day sensor mode. The lamp automatically turns on when the sensor detects movement during the day or at night (>30 lux) and turns off after a certain time when no movement is detected.
Position 3 - night sensor mode. The lamp automatically turns on when the sensor detects movement at night (< 30 lux) and turns off after a certain time when no movement is detected.
Switch #2. Setting the sensor induction delay:
1st position - 30 seconds;
2nd position - 60 seconds;
Position 3 - 180 seconds.
Switch #3. Light color temperature setting:
Position 1 - 2700K (warm white);
Position 2 - 3000K (warm white);
Position 3 - 4000K (neutral white);
Position 4 - 5000K (neutral white);
Position 5 - 6500K (cold white).
Switch #4. Light power setting:
1st position - 30W;
2nd position - 25W;
3rd position - 15W.
BATTERY REPLACEMENT
The product is equipped with replaceable batteries. If you notice that the battery has worn down over time, it can be replaced. Used batteries can only be replaced with batteries of the same type. Follow the steps below to replace the batteries.
a) Remove the lamp;
b) Unscrew the screws holding the transparent protective cover and remove the cover;
c) Insert new batteries according to the diagram (+/-) shown near the battery compartment;
d) Put back the transparent cover and fasten it with the appropriate screws;
e) Reinstall the lamp.
FUNCTIONAL CHARACTERISTICS
This product is intended for indoor use, but it can also be installed in wet rooms due to its IP44 moisture protection rating, such as basements, entrances, corridors, warehouses and other similar rooms where wet environments are possible.